Change Line Weights simualar to Adobe Reader

[IT-Service]

Hi @ all

we plan to migrate all our Adobe installations (over 1000te) to PDF- ExChange Viewer and Pro. At the moment we are in the evaluation step.
Now we are looking for the feature to change the line weights (simulare to the Adobe Reader . This is a important feature for our users. They have to check CAD- Pictures and there for they must can change the line weight to check the lines in a most easiest way. Is it possible to integrade this feature in the PDF- ExChangeViewer. At the moment i tested the version 2.0039 and i didn´t find ist.

Thanks in advanced

Mario

[Ivan - Tracker Software]

We can add this feature into build 40 of the viewer.

[IT-Service]

Hi Ivan

this would be great, because we need this feature and it would be a k.o. point for PDF- ExChange if this is missing.
Can you tell me when the bulid 40 is available?

Thanks Mario

[Lesya - Tracker]

The 40th build will be available by the end of September.

[IT-Service]

Hi

thx this sounds greate

[John - Tracker Supp]

Pleasure

[IT-Service]

Hi @All

now i had installed the Build 40 but i miss the mentioned feature. Can you tell when will it be implemented?
This is for us an important feature.

Thanks in advanced.

Mario

[John - Tracker Supp]

Hi Mario,

I suspect this may have been forgotten as it is not in the 'current' Viewer Forum - I have asked the project manager to reply - but would suggest in future all Viewer related questions go here :

https://forum.pdf-xchange.com/ ... m.php?f=35

Just to be 100% sure.


many thanks

[IT-Service]

Hi

thanks for the answer. In the furure i will write the posts in the right forum.
Is it possible to write a mail or to post if you knew when the feature will be available?

Thanks

Mario

[Ivan - Tracker Software]

Sure, this feature will be added. We didn't forgot about it, but to make acceptable realization of this feature, stroke adjusting algorithm should be realized. For now it is not finished, and we are very hope it will be done into build 41.

[IT-Service]

Hi Ivan

thx for this information Hope the feature will be available soon

Wish a nice weekend

Regards Mario