Panning past sheet edge

[Limeade]

I am moving over from Bluebeam to PDFXchange, one thing that is annoying me is that I cant pan past the edge of the sheet. See the attached example from Bluebeam vs PDFXchange. Is there a way to enable this or is it not something that PDFXchange can do at all. The nice thing about this feature is that I can put the corner or edge of the sheet in the middle of my screen rather than keeping it at the corner or edge of my screen which is difficult to read sometimes.

PDFXchange:

image.png

Bluebeam:

image(1).png

[Daniel - PDF-XChange]

Hello, Limeade

Thank you for the post, This has come up a few times, but at this time we are not planning an implementation of this feature. That may change in the future, and I will add your voice to the votes for it, but I cannot make any promises.

Kind regards,

[Limeade]

Thanks for the quick reply, is there a feature request or something that I can bookmark to keep track of this?

[Daniel - PDF-XChange]

Hello, Limeade

Nothing at the moment I am afraid.

Kind regards,

[Mathew]

Thanks for the quick reply, is there a feature request or something that I can bookmark to keep track of this?

I went looking for a past post - I'm certain there are a few - but could not think of the correct search terms. I'm of the same opinion: The limitations on scrolling pages outside the page boundary are very frustrating to me. I did make a tool that helps with dealing with viewing and accessing markups that go outside the page boundary: viewtopic.php?p=188981#p188981

But there are cases where a dialog will block the lower right corner, for example, and there's no way to access the corner. For example, if it were possible to scroll past the edge of pages, then the following would not be a problem:

image.png

or

image(1).png

Sometimes, just trying to scroll past the edge of the page when viewed in single page layout will make the page jump to the next page -- even more frustrating. I advocate that this long-standing issue gets seriously reconsidered. Thanks!

[Daniel - PDF-XChange]

Hello, Mathew

As before, I cannot make any promises, but the team will be looking at it soon to reconsider..

Kind regards,

[PHK]

One dirty workaround might be to Resize the page (either dimesions or percentages) so that the true content has sufficient margin around it. Like a matted picture in a frame.

If so desired, you could Resize back to the original dimensions when you are "done."

[Mathew]

One dirty workaround might be to Resize the page (either dimesions or percentages) so that the true content has sufficient margin around it. Like a matted picture in a frame.

If so desired, you could Resize back to the original dimensions when you are "done."

Yes that’s what my script does although it doesn’t do it for all sides…. Hmm. But I don’t think that is a viable option for many cases (locked pdfs, very large files, files that I shouldn’t make changes to, etc)

[PHK]

.that's why I call it dirty.

[PHK]

...

Yes that’s what my script does although it doesn’t do it for all sides….

v

image(3).png

The upper screenshot shows how you can center your content for all-around margins in this admittedly overblown example (for illustration purposes only).

Hmm. But I don’t think that is a viable option for many cases (locked pdfs, very large files, files that I shouldn’t make changes to, etc)

image(2).png

The lower screenshot is meant to put to bed that there is a problem with "very large files", another absurdity for illustration purposes.

If one cannot make changes (locked, etc.), then just zooming out a specific amount that suits one's needs in seeing what needs to be seen.