Measure Tool

[Tscale]

Hello all,

I'm new to the forum but have been using viewer for measurement for some time.

My question is, whilst taking dimensions the default visible lines are as thick as you arm and have massive arrows at each end.

I know,once the measurement has been taken, this can be changed in properties BUT can it be permanently changed so I don't have to make changes every time I open a new drawing?

Fingers crossed it can.

Cheer

[Stefan - PDF-XChange]

Hello Tscale,

Welcome to our forums.
You can change the way any of the tools looks and then make that the default look for all future uses of the same tool as described here:
How do I set the default appearance of an annotation in the Viewer/Editor

Regards,
Stefan