measure tool

[c.formenti]

Ho can I set the scale ratio in the measuring tool. Actually it is set to Km and I cannot find the way to reset. I cannot even type a different number in the measure pop-up. This software is great but I just miss this feature that I have been waiting from two previous versions.

[Bhikkhu Pesala]

Did you try a Search before posting?

[c.formenti]

Yes I have tried the suggestions but I cannot find the "property" window for the measuring tools. Then I have found that my upgrade to the new version 2.040 has not been successfull and I am still running the 2.039. When I try to download from the PDF-viewer help it runs for few seconds reaching 53299 number and then I get a message that the download is complete. When I confirm to proceed a new window of DOS opens and immediately an error message appears that the CPU has found a non valid instruction CS:0fc4 IP:0364 OP:63 75 2d 74 72 and when I close this window it remains the upgrade window telling me that the components have been succesfully upgraded but there is no upgrade to PDF viewer.

[Bhikkhu Pesala]

The properties toolbar is shown/hidden with the Control E shortcut. Also found on the View, Toolbars menu.

[c.formenti]

I see that there are no secrets for you and your help has solved definitively my problem. I was blind and deaf but at the end I have made it ! Thank you from Carlo F in Italy